1、The Dunyun gate valve accepts internal and external screw thread, flange and welding connection. The shell and valve cover are processed by hot forging and tempering, and the sealing surface is cut by high-precision sealing plane. The seal test strictly implemented according to GB / T13927-2008 Industrial Valve Pressure Test, the pipe thread accuracy and active length strictly implemented according to ISO228. The pre-factory test qualified rate is 100%.
2、Using the corresponding force torch wrench or pipe clamp to pull the thread on the same side of the hexagon or octagonal part screw thread active length when installation. Do not put excessive jacking pressure which may cause the deformation of internal end surface.
3、The hand wheel is designed according to the corresponding torque. Do not use the increased force arm which may damage the valve. Refrigeration, HVAC system gate valve must use the 1.6Mpa (or above nominal pressure) valve.
4、When installing the flange gate valve, please make sure that the flange surface at both ends of the pipeline is parallel and coaxial, the spacing size should be appropriate, the connection thread should be corresponding, and the deviation shall not be too large, otherwise the installation quality of the valve and sealing performance will be affected.
1、Used for frequent operation, which is easy and quick for open and close
2、small fluid resistance
3、Simple in structure, small in relatively volume, light in weight, which is easy to repair
4、Good sealing performance
5、The flow of media can be arbitrary without limitation of the direction of installation